Location: Home Page > Article Article

Computer dust is dust that accumulates on mainstream computers, monitors, keyboards, and other components and causes problems such as poor heating of electronic components, reduced heat dissipation, and deterioration in appearance of computers. To keep your computer running smoothly and prolonging life of your computer, you should regularly clean your computer of dust. In life, many people do not know how to clean computer from dust How can I clean computer from dust? The following will introduce you to method of cleaning your computer from dust and some related knowledge!

First of all! We need to prepare following tools:

1. Disassemble case

First, use a screwdriver to unscrew case screws, disassemble case, and remove case baffle. It can be clearly seen that most dusty places are video card, cooling fan, hard drive and bottom of case. chassis.

Second, remove removable piece of equipment

Remove removable parts such as graphics card, hard drive and memory card, and wipe surface with a dry cloth. If the surface is uneven, clean it with a brush. The cooling fan can be cleaned with a hair. dryer Be careful not to use hot air.

3. Gently erase golden finger with eraser

Part of golden finger should be gently rubbed with an eraser, which effectively removes dust and rust, and then wipe off remaining rubber with a paper towel.

Fourthly, clean bottom and surface of hull

The bottom and surface of case can be wiped with a damp cloth, but wait for it to dry before assembling.

5. Some details to pay attention to when cleaning screen

When cleaning screen, it is recommended to purchase a screen cleaning kit. First brush off dust, then spray cleaner onto microfiber cloth, and finally wipe screen. Do not spray cleaner directly onto screen.

6. Clean your keyboard and mouse

The last thing is keyboard and mouse. Use a brush or silica gel to clean dust and dirt from gaps in keyboard, and then wipe the keyboard and mouse with a rag. If it's a desktop computer keyboard, it's best to remove each keyboard and clean it so it can be cleaned more gently.

6. Replace CPU and GPU with thermal paste

Then it's a bit difficult to change silicon grease for a discrete graphics card. Here's what I'll say, be brave and careful, and there will be no problems! Remove any heat dissipation springs, backplane fixing screws, etc., and twist it up and down slightly to remove heatsink. You can see dried silicone grease on video card, and wipe it with alcohol and a cotton cloth (water can also be used, do this carefully). Replace original silicone grease with your own silicone grease, be careful not to use too much, just a little, then reset it, do not over-tighten cooling spring screws. tight, just fits right!

Replacing a CPU with silicone grease is relatively easy, just make a small wad in middle and press it right against heatsink!

How about this, removing dust is by no means as difficult as everyone imagines, but it is actually very simple. The main thing is to be careful not to damage electronic components, and to replace removed parts and screws. After removing dust, computer can fly again, oh yes! There is also a high pressure air gun that blows into body in an open area. This dust removal method is simple, furious, fast and clean! The only downside is that it can damage equipment and high pressure air gun is not easy to find so I will mention it at end...